Country Flame HR-01 Bedienerhandbuch PDF herunterladen (Seite 14)

14 - EN

Installer / Service Manual BURNiT Comfort PM/PM-B

3.8 Connection to the power supply

Once the pellet stove is installed in the room it must be connected to the power supply. The power

cable is situated at the back part of the pellet stove. Check the condition of the cable. If any damages

are noticed notify an authorized service for exchange.

Before connecting the pellet stove to the power supply check carefully:

 Whether the characteristics of the electrical supply match the requirements indicated on the

label of the pellet stove.

 Weather the connection is correctly grounded.

 The cable must not be with temperature higher than 75°C.

 In case of direct connection to the power supply – contact an authorized electrician to perform

the action.

 Turn off the pellet stove from the power supply when the product is not intended to be used for

a long period of time.

 The connection with the power supply must be easy to access in order to be able to easily

disconnect the plug in case of accidents.

4. INSTALLING AND FIRST START OF THE PELLET STOVE

ATTENTION

MUST BE PERFORMED ONLY BY AUTHORIZED INSTALLER

SERVICE

Connect all the necessary wires and plugs to the controller of the pellet stove. The installation is fast

and easy.

FIRST START OF THE PELLET STOVE:

- Make sure that all the wires are connected properly.

- Switch on the pellet stove.

- Perform the set up.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 55 56

Keine Kommentare

Country Flame HR-01 Bedienerhandbuch Seite 14